Rode Charge Case+ Charging Case for Wireless GO (Gen 3) and Wireless PRO

Rode Charge Case+: Charge, Store, and Transfer Your Wireless System in One Case

The Rode Charge Case+ is a compact charging case for the Wireless GO (Gen 3) and Wireless PRO wireless microphone systems, built around an integrated battery that delivers two full recharges for up to 21 hours of use. It does three jobs at once: it holds both transmitters and the receiver together in a rugged zip-close shell, it recharges all of them from a single USB-C cable, and it gives you data access to every unit for transferring recordings and updating firmware. For the creator who lives between shoots, it turns a loose handful of tiny wireless units into a single system that is always powered, always protected, and always ready to go.

Two Full Recharges Without a Wall Outlet

The heart of the Charge Case+ is its built-in battery, which stores enough power to fully recharge your wireless units twice over — up to 21 hours of additional recording time — without being plugged into anything. Drop the transmitters and receiver into the case between takes and they top up from the case itself, so a day of run-and-gun interviews, a multi-location shoot, or a long event never stalls because a transmitter ran flat. When you do reach mains power, a single USB-C cable refills both the units and the case's own battery, so you start the next day with a full reserve again. It is the difference between rationing battery life and simply forgetting about it.

Charge All Three Units From One USB-C Cable

A Wireless GO (Gen 3) or Wireless PRO kit is three separate devices — two transmitters and one receiver — and charging them individually means juggling cables and ports. The Charge Case+ charges all three simultaneously from one USB-C connection, so the whole system refills together in the time it takes one unit to charge on its own. A charging status LED on the case shows you the state of play at a glance, so you can tell whether the system is still filling or ready to pull and run.

More Than Power: Full Data Access to Every Unit

The Charge Case+ is not just a battery in a box. While your units sit in the case connected over USB-C, you also get simultaneous data access to the complete system — so you can transfer the on-board recordings from each transmitter, adjust settings, and push firmware updates to every unit at once. That means one connection at the end of a shoot handles both offloading your audio and keeping the whole kit up to date, instead of plugging in each unit separately.

Rugged Protection Built for the Road

Wireless transmitters and receivers are small, valuable, and easy to lose or knock around in a bag. The Charge Case+ answers that with a tough exterior and an innovative zipping design that keeps all three units cradled, safe, and together whether they are charging on your desk or riding in a backpack between jobs. Instead of hunting for a receiver in one pocket and a transmitter in another, you reach for one case that holds the entire system.

Who the Charge Case+ Is For

The Charge Case+ is for the mobile creator, videographer, interviewer, or event shooter who relies on a Wireless GO (Gen 3) or Wireless PRO and cannot afford to run out of power or misplace a unit mid-job. If you shoot away from wall outlets, move between locations, or simply want your whole wireless kit to charge, store, transfer, and update in one place, this is the accessory that keeps the system ready the moment you are.