Rohn Products VP35065 65G Tower 350 FT Climbing Safety Cable System

Tower Climbing Safety System for Up to 350 Foot Rohn 65G Installations
The ROHN VP35065 is a vertical safety cable system built for Rohn 65G and 65GSR towers up to 350 feet in height. This kit provides the fixed climbing components required for fall protection compliance under Rev. G regulations, which mandate a climber safety device for any tower over 10 feet. Designed for integration with fall arrest gear (sold separately), the VP35065 offers critical safety infrastructure for professional climbers accessing tall towers in telecom, broadcast, and utility installations.

Includes Top and Bottom Mounting Brackets With 3/8 Inch Safety Cable
This system comes complete with top and bottom anchor brackets, cable restraint fixtures, and 3/8" solid-core safety cable—everything needed to install a continuous vertical lifeline on a 65G tower up to 350 feet tall. The cable is tensioned between the anchors to allow a wire grab or trailing fall arrest device (not included) to move smoothly with the climber during ascent and descent, providing uninterrupted protection in the event of a fall.

Complies With ANSI and OSHA Tower Climbing Safety Requirements
Tower safety requirements under ANSI Z359 and OSHA 1926 Subpart M demand fall protection systems on structures exceeding certain heights, and the ROHN VP35065 ensures you're compliant with these standards. Once installed, it becomes a key part of a vertical fall protection system that minimizes risk and supports secure climbs for trained personnel.

Compatible With Vertical Fall Arrest Devices and Harness Systems
This kit is designed for use with a separate wire grab unit such as the TT-WG-500, compatible with 3/8-inch solid-core cable. It supports smooth travel up and down the tower while locking instantly in the event of a fall. A properly rated body harness and wire grab are required to complete the full vertical fall protection setup and are sold separately.

Optimized for Rohn 65G and 65GSR Series Tower Structures
Specifically made for ROHN’s 65G and 65GSR tower lines, the VP35065 system mounts securely to the structural geometry of these heavy-duty towers. The design integrates with the tower's bracing and layout to maintain alignment and avoid cable interference. All hardware is engineered to perform reliably in outdoor conditions and high-elevation environments.

Field-Proven Safety Component for Long-Term Tower Access
Whether you're servicing microwave antennas, performing inspections, or maintaining RF hardware, this system ensures climbers have a dedicated safety line installed and ready for use. Once in place, it becomes a permanent fixture of the tower, improving both access and compliance for ongoing operations at height.

Meets Rev. G Tower Safety Requirements for Structures Over 10 Feet
Following Rev. G tower safety standards, any fixed ladder or vertical access system on structures exceeding 10 feet in height must include a fall protection device. The VP35065 provides a secure, structured solution to meet these guidelines for towers up to 350 feet, helping site managers avoid liability while protecting their climbing crews.